Delfield N8600 Specifiche Scaricare il pdf (Pagina 14)

N8000 Series Drop-In Installation and Operation Manual

For customer service, call (800) 733-8829, (800) 733-8821, Fax (989) 773-3210, www.deleld.com

Operation N8200 & N8200-ST

N8200 and N8200-ST Series frost tops are designed to maintain

an even layer of frost to pleasantly display product. Once turned

on, the compressor will run continuously. The unit should be

turned off overnight or when not in use. There is no temperature

control. The ON/OFF switch is the only means available to cycle

the unit.

Since it takes time for the frost to accumulate initially, the unit

should be turned on approximately one hour before it is actually

required. Product should not be placed on the frost top prior to

turning the unit on, because it may freeze to the surface of the

unit.

The unit must be turned off when not in use or overnight for

defrosting and cleaning.

Operation N8200G

N8200G Series granite cold slabs are designed to maintain a

low temperature surface for quick turn products such as ice

cream. Frost patterns will vary depending on room conditions

such as temperature, humidity and airow. The “work zone”

of the granite surface is considered to be inside a 2” (5.1cm)

perimeter. Temperatures in the perimeter zone may be higher

and again the frost patterns in this area will vary based on room

conditions.

Unit is controlled by an on/off switch. Once turned on, the unit

will run continuously. There is no temperature control in this unit.

Turn the unit on approximately two hours prior to use to allow

for ample cool down time. The unit must be turned off when not

in use or overnight for defrosting and cleaning.

There is a switch on the compressor housing front to turn the

8100-EF units on and off. 8100-EF Series LiquiTec

Eutetic

uid cold pans are adjusted at the factory to provide proper

operation without any further adjustments. However, if it is

necessary to adjust the temperature, the control is located in

the machine compartment. Turn the knob clockwise as indicated

on the control to adjust it colder. Adjustments should be made

gradually. Several small adjustments will be more effective than

one large adjustment. It may take an hour or longer to realize

the temperature change depending on the application and

location of the unit.

The cold pan is not intended to be used with

ice.

Operation 8100-EF Series

The unit must be turned off when not in use or overnight for

defrosting and cleaning.

Temperature Control Settings:

17°F (8ºC) differential

25°F (-4ºC) cut-in

8°F (-13ºC)cut-out

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Commenti su questo manuale

Nessun commento

Delfield N8600 Specifiche Pagina 14

Commenti su questo manuale

Prodotti e manuali riguardandi no Delfield N8600