Delfield N8600 Specifiche Scaricare il pdf (Pagina 12)

N8000 Series Drop-In Installation and Operation Manual

For customer service, call (800) 733-8829, (800) 733-8821, Fax (989) 773-3210, www.deleld.com

These units are intended for indoor use only. Be sure the location

chosen has a counter strong enough to support the total weight

of the unit and contents. A fully loaded model may weigh as

much as 600 pounds! Reinforce the counter as necessary to

provide maximum loading.

Unit requires that the sides and bottom are not

any closer than 3” (7.6cm) to any combustible

material.

The counter cut-out sizes and power requirements are shown

on the specication pages. A gasket is installed in the ange

of each unit. The weight of the unit on the gasket forms a seal

preventing liquids from seeping into the cut-out opening.

N8700 Series pans should be installed with the

drains at the back, away from the operator’s

sides.

The controls on N8700-D, N8700-DESP, N8700-R and N8800

series units are mounted in a control panel, designed to be

installed at a “remote” location. The control panel should be

installed so that the indicator light for each control is to the

right of the control. N8700, N8700N and N8700-R series units

have 48” (121.9cm) of conduit and N8800 Series units have 24”

(61.0cm) of conduit between the pans and the remote control

panel to facilitate this installation.

Plumbing

N8700-D, N8700-DESP, N8700N-D and N8700-R Plumbing:

Unit is equipped with 1/2” (1.3cm) drains, (one per well located

in right rear corner 1/2” (1.3cm) female N.P.T.) manifold and 1/2”

(1.3cm) gate valve.

N8800 Plumbing: Well is sloped to a 1.00” (2.5cm) male N.P.T.

stainless steel drain.

Moisture collecting from improper drainage

can create a slippery surface on the oor

and a hazard to employees. It is the owner’s

responsibility to provide a container or outlet

for drainage.

Electrical connection

Refer to the amperage data on the specication pages, the

serial tag or your local code to be sure the unit is connected to

the proper power source.

The unit must be disconnected from the

power source whenever performing service

or maintenance functions.

CAUTION

DANGER

Installation N8700-D, N8700-DESP, N8700N, N8700-R & N8800 Series

Control Panel Installation, N8700-D, N8700-DESP, N8700N & N8700-R Series

Drains

Control panel

installed

opposite drains

The control panel is designed to be installed on the side

opposite the drains.

If you choose to install the control panel on the same side as the

drains the control panel will either be upside down or the knobs

will control the opposite wells.

Inﬁnite control shown, directions also apply to digital control

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Commenti su questo manuale

Nessun commento

Delfield N8600 Specifiche Pagina 12

Commenti su questo manuale

Prodotti e manuali riguardandi no Delfield N8600